How to make tables for the diploma

Each university in its requirements for completing a diploma can set its own rules, as there are no approved regulatory documents governing this issue. Nevertheless, the general view should comply with GOST 7.32-2001, so you can safely make out tables for the diploma according to the following rules.

You will need

• - Microsoft Word text editor;

• - guidelines.

Instruction manual

one

For each table in the text, make a reference (link), with a brief clarification of the contents. For example, write: "the consumption of components by units is presented in table 1.2." Place the table itself immediately after the text in which it was mentioned, or on the next page.

2

Assign each table an individual number and name, while the numbering can be end-to-end (for the entire diploma, for example, “Table 8”) or for sections (each section is separate, in this case, indicate the section before the table number, for example, “Table 3.4”) For tables placed in the annex, the designation of the annex should be indicated in the number, for example, “Table A.2”.

3

The word "Table" always write in full, without abbreviations. After the number through the dash, put the name of the table, do not put a dot at the end, for example, "Table 2 - Firm revenues." Place the title on the left above the table in one line, without indentation.

4

If you need to transfer part of the table to another page, write a heading with the name only above the first part, and only indicate the number above the other parts, for example, "Continuation of table 2". In this case, do not draw the lower horizontal line under the first part. If the columns go beyond the page border, then in the second part repeat the sidebar, and if the rows go out, then the table head. You can also not overwrite the names of columns or rows, but replace them with the corresponding number. In this case, number the first row or column of the first part of the table.

5

Headings of rows and columns, as well as independent subheadings, write in the singular and with a capital letter. If the subheadings are a continuation of the headings, then start them with a lowercase letter. All records should be parallel to the rows, but if necessary, write the column names perpendicularly.

6

Separate the table head with a horizontal line, but you can not separate the rows if this does not interfere with the use of the table.

note

Please note that each university has its own requirements that describe the design of tables for the diploma. Therefore, before passing the diploma, be sure to read the methodological instructions of your educational institution.