How to get a review

In the epic called "thesis" there are many components in addition to the main and main - directly writing a diploma. Including protection will not take place if there is no review of the final work. And the review, in turn, cannot be considered full-fledged if it is not formalized in accordance with accepted standards.

Instruction manual

one

The rules for processing documents related to a diploma are spelled out in the university regulations on WRC (graduate qualification work) and can be adjusted in each of the universities. Therefore, before using our recommendations, take a position at the department.

2

Starting directly to the design, turn on Caps Lock and set the text alignment to width and single spacing. With the Times New Roman headset, write the word "Review" (without quotation marks) using 14 point size. Go to the next line.

3

Having disconnected the caps, type in the lowercase letter "for thesis" (either a graduation project or a master's thesis, depending on the type of peer-reviewed work). Select this and the previous line in bold. Indent one line down.

4

The following lines are not bold and are typed when text alignment is turned on. With a capital letter write “Student” (or student) and add the surname, name and patronymic of the author of the diploma in the genitive case. Press Enter and name the code and the name of the training, specialty (for example, "Specialty 050505" Journalism "). On the next line, write the name of the profile or specialization, if any.

5

After another indent follows the title of the theme of the thesis: "Subject:" Such-and-such."

6

Double-clicking on the Enter key, you can type the main text of the review. It should contain an assessment of the relevance of the topic, an analysis of the main provisions, methods and depth of research, compliance with the rules of design of the WRC. The reviewer must draw a conclusion about the practical significance of the work and give an assessment on a four-point scale, as well as a recommendation on assigning a student a certain qualification.

7

The reviewer's signature is sometimes required to be certified in the office of the university in which he works.

eight

After the main text write “Reviewer”, put a comma and from a new line enter the degree, rank, position of an expert and place of work (in full) - this information should be located on the left side of the sheet, in a column. A place for signature is left in the center of the sheet, and the initials and surname are called on the right. From a new line - the number in quotation marks, the month (in word) and the year in full.